ANALISA RESIKO KESELAMATAN KERJA KARYAWAN PRODUKSI SEPATU DIVISI NIKE DENGAN METODE HIRARC (HAZARD IDENTIFICATION, RISK ASSESSMENT, AND RISK CONTROL) DI PT. NIKOMAS GEMILANG
DOI:
https://doi.org/10.46306/ncabet.v3i1.138Keywords:
Occupational Safety and Health, Risk , Keselamatan dan Kesehatan Kerja, Resiko dan HIRARCAbstract
Occupational Safety and Health (K3) is an issue that must be considered by all organizations, for example in industry. Based on observations and interviews of the production department at the Nike Division of PT. Nikomas Gemilang, There have been work accidents ranging from light to severe categories.
The Hazard Identification, Risk Assessment and Risk Control (HIRARC) method in the production process with hazard identification steps (Hazard Identification), risk assessment (Risk Assessment) classifies based on the severity of the hazard posed (Severity). The last step is to multiply the Likelihood value and Severity value that will be mapped into the Risk Matrix.
Hazard identification using Job Safety Analysis (JSA) 33 potential hazards were obtained in the production section at PT. Nikomas Resplendent Nike Division. There are 3 types of hazards that exist in the entire production process, namely: ergonomic hazards, physical hazards and chemical hazards. From the results of the risk assessment, it was found that the risk in the Low category was 11 (34%) potential, while in the Medium category there were 10 (30%) potentials, the High category as many as 8 (24%) potentials and the Very High category 4 (12%) potentials.
Control that can be done to reduce risk is the use of Personal Protective Equipment (PPE) for workers, so that workers can safely and comfortably work and are installed warning signs in every corner of the room to prevent accidents
References
Mariah Q., Wardiati & Dedi Andria. (2022). ‘Analisis Risiko Keselamatan Kerja Menggunakan Metode Hazard Identification, Risk Assessment dan Risk Control (HIRARC) Pada Divisi Mechanical Engineering PDAM Tirta Daroy Kota Banda Aceh Tahun 2022’, Journal Of Health and Medical Science, pp. 249-259.
Basuki, G. (2019). ‘Identifikasi Bahaya Bekerja Pada Departmen Casting Dengan Hazard Identification, Risk Assessment and Risk Control Di PT. Prima Alloy Steel’, KAIZEN : Management Systems & Industrial Engineering Journal, 2(1).
Khasanah, U. & Suryani, D. (2019). ‘Analisis Risiko Kesehatan Kerja Pada Pekerja Pembuatan Sepatu Di Home Industri Sepatu Kulit Manding Yogyakarta’, Universitas Ahmad Dahlan, pp. 1-16.
Hidayat, M.C. & Nurudin, M. (2021). ‘Analisis Identifikasi Bahaya Kecelakaan Kerja Menggunakan Job Safety Analysis (JSA) dengan pendekatan Hazard Identification, Risk Assessment and Risk Control (HIRARC)’. JUSTI (Jurnal Sistem & Teknik Industri), 2(4), pp. 557-571.
Austin, K (2020). ‘Health Services Assistance: Supporting Nursing In Actue Care. Australia: Cengage AU.AS/.NZS 4360 Australian/New Zealand Standard Risk Management.
Downloads
Published
How to Cite
Issue
Section
License
Copyright (c) 2024 Yopie Widianto, Budiharjo, Sherin Ramadhania
This work is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License.